The Model CM325R is a single head version of the
Model CDM300R (see Page Nos. 16 & 17). This
saw incorporates most of the standard features
found on the CDM300R. In addition, the CM325R
will mitre up to 45° to the left of 0°, and up to 60°
to the right of 0°.

STANDARD FEATURES
& SPECIFICATIONS:

Blade Capacity: 12” OD (305mm); saw blades not included.

Arbor: 1” (25mm) with 2-1/2” (64mm) saw scollars;
3700 RPM of spindle.

Motors & Voltages: 3 H.P. 3 Phase 230/460 Volt Totally
Enclosed Fan Cooled Motor, 60 Hz 3450 RPM; optional
starter available for voltage protection.

Compound of Tilting Angle: Saw head will compound
angle cut up to 45° in direction shown, with positive pin
stops at 90°, 22-1/2°, and 45°. Saw will cut up to 10° on
the other side of the vertical plane.

Actuation: Hand operated standard; optional power
down feeds of sawheads actuated by Two-Hand,
Anti-Tie Down Maintained Contact Safety Control.

Cutting Capacity: 45° Mitre; 3-1/4” (82mm) High x 5”
(127mm) Wide 90° Straight Cut; 2-1/2” (63mm) High x 7”
(178mm) Wide 90° Front to Back/45° Compound;
1” (25.4mm) High x 7” (178mm) Wide

CM325R Standard Chop Saw
Optional left head shown