CTD Model CM325R 12” Mitre & Compound Mitre Saw

CTD Model CM325R 12” Mitre & Compound Mitre Saw

12” Mitre & Compound cut-off saw


The Model CM325R is a single head version of the Model CDM300R see Page Nos. 16 & 17. This saw incorporates most of the standard features found on the CDM300R. In addition, the CM325R will mitre up to 45° to the left of 0°, and up to 60° to the right of 0°.
Item # :  CM325R
 IMAGE_CLOSE
  • *Mitre & Compound cut-off saw.
  • *Blade Capacity: 12”
  • *3 H.P. 3phase
  • *3450 RPM
  • *Cutting Capacity
  • 45°: 2½” X 4½”
  • 90°: 2½” X 5”
  • Compound: 1” X 7”

Blade Capacity 12” OD 305mm; saw blades not included.

Arbor 1” 25mm with 2-1/2” 64mm saw scollars; 3700 RPM of spindle.

Motors & Voltages 3 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motor, 60 Hz 3450 RPM; optional starter available for voltage protection.

Compound of Tilting Angle Saw head will compound angle cut up to 45° in direction shown, with positive pin stops at 90°, 22-1/2°, and 45°. Saw will cut up to 10° on the other side of the vertical plane.

Actuation Hand operated standard; optional power down feeds of sawheads actuated by Two-Hand, Anti-Tie Down Maintained Contact Safety Control.

Cutting Capacity 45° Mitre; 3-1/4” 82mm High x 5” 127mm Wide 90° Straight Cut; 2-1/2” 63mm High x 7” 178mm Wide 90° Front to Back/45° Compound; 1” 25.4mm High x 7” 178mm Wide