CTD MODEL D20R A revolutionary idea--right
and left saw heads, individually operated on a common
base. Gives you a fast, accurate double mitre cut-off that
beats anything in it’s price class in the world.

STANDARD FEATURES
& SPECIFICATIONS:

Blade Capacity: 12” OD (305mm);
saw blades not included.

Spindle & Pivot: Both mounted on pre-loaded
and sealed bearings; uses our time tested
200R Series saw head; saw arm, pivot brackets
and table are precision machined and ground
steel plate and iron.

Arbor: 1” (25.4mm) with 2-1/2” (64mm) saw collars;
3700 RPM of spindle.

Motors & Voltages: 1 H.P. single phase, 115 Volt,
Totally Enclosed Fan Cooled Motors with toggle
switch and plug; each motor draws 15 amps at 115 Volt;
completely enclosed 2-belt drive; 230 Volt
with Dual Magnetic Starter available.

Floor Stand: Close coupled heavy gage steel floor
stand with removable dust and scrap drawer;
Rabbet Measuring System included.

Actuation: Manual hand operation of independent
saw heads.

Size & Weight: 46” (117cm) Wide x 22” (56cm) front
to back x 56” (142cm) High”; Weight 300 lbs. (136 kg).

Production Rate: Up to five frames per minute; actual
production rates vary with the type and width of
material to be cut.

Dust Collection & Scrap: The D20R is provided with
a dust and scrap drawer; most of the dust and chips
will fall into this drawer; empty as needed; 4” (102mm)
dust outlet available; 600 CFM required.

Model D20R Package Shown Includes Blades

D20R Cutting Chart
with rabbet angle