The D45 is popular world wide because of its
unique features, low cost and precision.
Engineered for higher production, this double
mitre saw makes two 45° mitres at one time,
saving time and materials. D45’s are used
by thousands in the decorative arts trade
throughout the world.

STANDARD FEATURES
& SPECIFICATIONS:

Blade Capacity:  
Saw blades not included.
14" OD (356mm)

Spindle & Pivot: Both mounted on pre-loaded
and sealed ball bearings.

Arbor: 5/8” (16mm) with 2-1/4” (57mm) saw collars.

Iron Castings: Saw arm, pivot brackets and table
are precision machined and ground with milled
slots in table to guide pivot brackets and fences.

Motors & Voltages: 2 H.P. (3 H.P. optional) 
3  phase 230/460 Volt, Totally Enclosed Fan Cooled Motors, 60 Hz, 3450 RPM with Dual Magnetic Starter.  Also includes rotary disconnect switch and blade guard interlock switch. Consult factory for amperage load of motors.

Table Height: 34-1/2” (88cm) from floor.

Floor Stand: Close coupled heavy gage steel
stand completely enclosed with 6” dust outlet.
1200 CFM required.

Blade Wear & Angular Adjustments: Each saw
head has adjustments for blade variation. Allows
for precision alignment of blades to minimize scrap.
Saw heads are adjustable up to 3°, always
assuring perfect mitres.

Length of Stroke Adjustment: The D45AX is
unique in that the stroke of the machine and the
position of the blade above the work can be
adjusted to use only the stroke needed to cut
a particular moulding or extrusion. Saw heads
reverse immediately, thereby saving wasted time
and motion.

Production Rate: The D45AX is capable of
cycling at one second intervals. However,
actual production rates vary with the type and
width of material to be cut.

Size: Standard machine, without tables or gages;
Weight 550 lbs. (250kg); 46” (117cm) Wide x 22”
(56cm) front to back x 51-1/2” (131cm) High.

Crated Size: 45” (114cm) Wide x 28 -1/2”
(72cm) front to back x 60” (152cm) High.

Actuation: Pneumatic foot valve with cover.

Air Pressure: 75 PSI (5.4 kg/cm2) with Air
Filter/Regulator/ Lubricator; includes Auto Drain.

Air Consumption: 1.0 CF per 10 strokes at 75 PSI
(.043 cubic meters per minute at 5.4 kg/cm2).

Model D45AX Automatic
*Optional Extras Available

14" Blade High - Top