Toll Free: 888-612-5889
Phone: 213-689-4455
Fax: 213-689-1255

E-mail: ctdsaw@ctdsaw.com
Mon-Fri: 7:30 AM - 4:30 PM PST
Sign In Register Order Status View Cart

CTD Model DM200R 12

CTD Model DM200R 12

12" Double end trim mitre saw

Item # :  DM200R
  • *Double end trim mitre saw
  • *Blade Capacity: 12"
  • *2 H.P. 3phase
  • *Magnetic Starter
  • *10 strokes per min.
  • *Mitres up to 45°
  • *Cutting Capacity:
  • 45°: 1½" X 5"
  • 90°: 2" X 7¾

Spindle & Pivot
Uses our time tested 200R Series Saw Head; precision ball bearing spindle and pivot shaft are sealed and preloaded for guaranteed accuracy; .001 alignment of spindle and pivot shaft.

1" 25mm with 2-1/2" 64mm saw collars; 3700 RPM of spindle.

Motors & Voltages
2 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motors, 60 Hz, 3450 RPM, with starters and voltage protection; 3 H.P. 3 Phase motors available.

Iron Castings
Tables are precision machined and ground iron castings with milled keyways in tables to guide fences.

Saw heads swivel from 90° to 45° towards each other with degree markings and pointer; stops are at 90° and 45°; angular adjustment of saw head away from each other available as option; other angles possible; phenolic chip breaker included.

Floor Stand
Heavy gage steel; eight foot centers with traveling right hand carriage on rack and pinion; length measuring scale; optional length centers available to 40 feet 12M; Digital Length Measurement available as optional accessory.

Blade Guard
Completely encloses blade in rest position. Lower rotating blade guard pivots up into main stationary blade guard as saw heads pivot down to cut.

On each side of blade are keyed to base and are easily adjustable front to back, and side to side.

Two inside vertical clamps must be tripped by foot valve, then a two-hand anti-tie down, maintained contact safety control will work the air downfeed of saw heads. An air filter/regulator/lubricator with auto drain is provided.

Air Pressure & Consumption
75 PSI 5.2kg/cm2; 3 CFM at 75 PSI .09 cubic meters at 5.2 kg/cm2, based on 10 strokes per minute.

Dust Collection
Four, 2" round 51mm outlets are provided, two on each saw head for DM200R; 800 CFM required per saw head.

Production Rates
10 strokes per minute; actual production rates will vary with type and width of material to be cut.

Size & Weight
32" 81cm front to back x 64" 163cm High x 120" 305cm Long; Weight 1,050 lbs. 476kg.

Tax Deduction Info on www.Section179.Org!
CTD Machines
2382 E 48th St, Vernon CA 90058
Phone 213-689-4455 / Fax 213-689-1255
E-mail: ctdsaw@ctdsaw.com
Copyright © 2019 CTD Machines. All rights reserved.
Shopping Cart Software powered by ecMidas.