Models M416 & F426, 16" OD 406mm; Models M516 & F526, 20" OD 504mm; saw blades not included.
1" 25mm with 5" 127mm saw collars.
Spindle & Pivot
Spindle mounted on preloaded and sealed bearings; with V-belt drive completely enclosed; pivot uses Timken bearings lubricated for life.
Motors & Starters
8-1/2 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motor with Magnetic Starter standard; 10 H.P. & 15 H.P. motors available as optional extra.
Heavy gage steel sheet and angle.
Precision machined cast iron base with milled keyways to guide fences; disc set flush with base.
Two 4" 102mm outlets provided; 1200 CFM required.
Up to 10 strokes per minute; actual production rates will vary with the type and width of the material to be cut.
Hand operated standard; optional Power Downfeeds of Sawheads actuated by Two-Hand, Anti-Tie Down Maintained Contact Safety Control.
Air Pressure & Consumption
3 CFM at 80 PSI .09 cubic meters/minute at 5.6 kg/cm2 based on 10 strokes per minute; air filter/regulator/lubricator with auto drain included.
Size & Weight
48" 122cm Wide x 40" 102cm Front to Back x 70" 178cm High; Weight is 850 lbs. 386kg.
Optional Extras Include
Power downfeed of sawhead, clamps, measuring system and table supports