The Model N90 has been designed for a variety of heavy duty
cutting applications, such as 45° double mitre cutting, notching
of aluminum and plastic extrusions, or toe-notching of wood
panels. This heavy duty machine can have blades set for
notching or mitering. Blades move vertically on linear
bearings on 1-1/4" (32mm) diameter hardened and ground rods.
Keyed fences allow for each set-up and accurate dimensional changes.

STANDARD FEATURES & SPECIFICATIONS:

Blade Capacity: 16" OD (406mm); saw blades not included.
                             18" OD (457mm); optional

Arbor: 1" (25mm) with 3-1/2" (89mm) saw collars; mounted on
preloaded and sealed bearings; 2-belt drive; 2800 RPM of spindle.

Motors & Voltages: Two, 3 H.P. 3 Phase 230/460 Volt Totally
Enclosed Fan Cooled Motors, 60 Hz, 1725 RPM with Dual
Magnetic Starter; 5 H.P. Motors available.

Table Base: Precision machined and ground iron castings
with milled keyways to guide fences; allows for easy and
accurate dimensional changes.

Floor Stand: Heavy gage steel; stand is completely enclosed
with 6" (152mm) dust collector outlet and scrap chute;
1200 CFM required.

Actuation: Air operated by foot valve with cover.

Air Pressure & Consumption: 6 CFM at 100 PSI
(.17 cubic meters/minute at 7.03 kg/cm2) based on
6 strokes per minute;
includes air filter/ regulator/lubricator with auto drain.

Size & Weight: Standard Toe-Notch Machine 42"
(107cm) Wide x 42" (107cm) front to back x 62" (157cm)
High; Weight 900 lbs. (410kg).

Production Rate: Up to 10 strokes per minute.

Cutting Capacity: Staggered Saw Blades/ Toe-Notch
Configuration; 6" (152mm) x 6" (152mm) Deep
x 4" (102mm) High

Mitre Cutting/Staggered Saw Blades;
4-1/8" (105mm) Wide x 4" (102mm) High

Mitre Configuration/Non-Staggered Saw Blades;
4" (102mm) Wide x 4" (102mm) High; up to 6" (152mm)
High with special blade guard modification at extra charge.

Model N90 Toe-Notch Configuration

Slide and Spindle View,
Blade Guard Removed

Rear View with Dust Cover Removed