Model F526 20

Model F526 20

20" Straight cut-off saw

Incorporates all the standard features of Models M416 & M516 except that the machines cut 90° only.
Item # :  F526
  • *Straight cut-off saw
  • *Blade Capacity: 20"
  • *8½ H.P. 3 phase
  • *Magnetic Starter
  • *10 strokes per min
  • *90° Only
  • *Cutting Capacity 90°: 5½" X 11½

Blade Capacity
Models M416 & F426, 16" OD (406mm); Models M516 & F526, 20" OD (504mm); saw blades not included.

1" (25mm) with 5" (127mm) saw collars.

Spindle & Pivot
Spindle mounted on preloaded and sealed bearings; with V-belt drive completely enclosed; pivot uses Timken bearings lubricated for life.

Motors & Starters
8-1/2 H.P. 3 Phase 240/460 Volt Totally Enclosed Fan Cooled Motor with Magnetic Starter standard; 10 H.P. & 15 H.P. motors available as optional extra.

Floor Stand
Heavy gage steel sheet and angle.

Table Base
Precision machined cast iron base with milled keyways to guide fences; disc set flush with base.

Dust Outlet
Two 4" (102mm) outlets provided; 1200 CFM required.

Production Rate
Up to 10 strokes per minute; actual production rates will vary with the type and width of the material to be cut.

Hand operated standard; optional Power Downfeeds of Sawheads actuated by Two-Hand, Anti-Tie Down Maintained Contact Safety Control.

Air Pressure & Consumption
3 CFM at 80 PSI (.09 cubic meters/minute at 5.6 kg/cm2) based on 10 strokes per minute; air filter/regulator/lubricator with auto drain included.

Size & Weight
48" (122cm) Wide x 40" (102cm) Front to Back x 70" (178cm) High; Weight is 850 lbs. (386kg).

Optional Extras Include
Power Downfeeds of Sawheads, Clamps, Measuring Systems and Table Supports.