top of page
BUY- NEW

12” Mitre & Compound cut-off saw

The Model CM325R is a single head version of the Model CDM300R see Page Nos. 16 & 17. This saw incorporates most of the standard features found on the CDM300R. In addition, the CM325R will mitre up to 45° to the left of 0°, and up to 60° to the right of 0°.

Specifications

  • Mitre & Compound cut-off saw.

  • Blade Capacity: 12”

  • 3 H.P. 3 phase

  • 3450 RPM

  • Cutting Capacity

  • 45°: 2½” X 4½”

  • 90°: 2½” X 5”

  • Compound: 1” X 7”

Cutting Capacity 

  • 45° Mitre; 3-1/4” 82mm High x 5” 127mm Wide 90° Straight Cut; 2-1/2” 63mm High x 7” 178mm Wide

  • 90° Front to Back/45° Compound; 1” 25.4mm High x 7” 178mm Wide

Actuation

  •  Hand operated standard; optional power down feeds of sawheads actuated by Two-Hand, Anti-Tie Down Maintained Contact Safety Control.

Motors & Voltages

  • 3 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motor, 60 Hz 3450 RPM; optional starter available for voltage protection.

Compound of Tilting Angle 

  • Saw head will compound angle cut up to 45° in direction shown, with positive pin stops at 90°, 22-1/2°, and 45°. Saw will cut up to 10° on the other side of the vertical plane.

Arbor

  • 1” 25mm with 2-1/2” 64mm saw scollars; 3700 RPM of spindle.

Blade Capacity 

  • 12” OD 305mm; saw blades not included.

contact
bottom of page