top of page
BUY- NEW

12" Double end trim mitre saw

TBA

Specifications

  • Double end trim mitre saw

  • Blade Capacity: 12"

  • 2 H.P. 3phase

  • Magnetic Starter

  • 10 strokes per min.

  • Mitres up to 45°

  • Cutting Capacity:

  • 45°: 1½" X 5"

  • 90°: 2" X 7¾

Spindle & Pivot 

  • Uses our time tested 200R Series Saw Head; precision ball bearing spindle and pivot shaft are sealed and preloaded for guaranteed accuracy; .001 alignment of spindle and pivot shaft.

Arbor

  • 1" 25mm with 2-1/2" 64mm saw collars; 3700 RPM of spindle.

Motors & Voltages 

  • 2 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motors, 60 Hz, 3450 RPM, with starters and voltage protection; 3 H.P. 3 Phase motors available.

Iron Castings 

  • Tables are precision machined and ground iron castings with milled keyways in tables to guide fences.

Air Pressure & Consumption 

  • 75 PSI 5.2kg/cm2; 3 CFM at 75 PSI .09 cubic meters at 5.2 kg/cm2, based on 10 strokes per minute.

Dust Collection 

  • Four, 2" round 51mm outlets are provided, two on each saw head for DM200R; 800 CFM required per saw head.

Table 

  • Saw heads swivel from 90° to 45° towards each other with degree markings and pointer; stops are at 90° and 45°; angular adjustment of saw head away from each other available as option; other angles possible; phenolic chip breaker included.

Floor Stand 

  • Heavy gage steel; eight foot centers with traveling right hand carriage on rack and pinion; length measuring scale; optional length centers available to 40 feet 12M; Digital Length Measurement available as optional accessory.

Blade Guard 

  • Completely encloses blade in rest position. Lower rotating blade guard pivots up into main stationary blade guard as saw heads pivot down to cut.
     

Fences 

  • On each side of blade are keyed to base and are easily adjustable front to back, and side to side.

Actuation 

  • Two inside vertical clamps must be tripped by foot valve, then a two-hand anti-tie down, maintained contact safety control will work the air downfeed of saw heads. An air filter/regulator/lubricator with auto drain is provided.

Production Rates 

  • 10 strokes per minute; actual production rates will vary with type and width of material to be cut.

Size & Weight 

  • 32" 81cm front to back x 64" 163cm High x 120" 305cm Long; Weight 1,050 lbs. 476kg.

Instructions Manual

contact
bottom of page