top of page
M416 New
M416 New

press to zoom

press to zoom
M416 CHB
M416 CHB

press to zoom
M416 New
M416 New

press to zoom

20" Straight cut-off saw

Incorporates all the standard features of Models M416 & M516 except that the machines cut 90° only.


  • Straight cut-off saw

  • Blade Capacity: 20"

  • 5 H.P. 3 phase

  • Magnetic Starter

  • 10 strokes per min

  • 90° Only

  • Cutting Capacity 90°: 5½" X 11½

Blade Capacity 

  • Models M416 & F426, 16" OD (406mm); Models M516 & F526, 20" OD (504mm); saw blades not included.


  • 1" (25mm) with 5" (127mm) saw collars.

Spindle & Pivot 

  • Spindle mounted on preloaded and sealed bearings; with V-belt drive completely enclosed; pivot uses Timken bearings lubricated for life.

Motors & Starters 

  • 5 H.P. 3 Phase 240/460 Volt Totally Enclosed Fan Cooled Motor with Magnetic Starter standard; 8½ H.P., 10 H.P., & 15 H.P. motors available as optional extra.

Floor Stand 

  • Heavy gage steel sheet and angle.

Table Base 

  • Precision machined cast iron base with milled keyways to guide fences; disc set flush with base.

Dust Outlet 

  • Two 4" (102mm) outlets provided; 1200 CFM required.

Production Rate 

  • Up to 10 strokes per minute; actual production rates will vary with the type and width of the material to be cut.


  • Hand operated standard; optional Power Downfeeds of Sawheads actuated by Two-Hand, Anti-Tie Down Maintained Contact Safety Control.

Air Pressure & Consumption 

  • 3 CFM at 80 PSI (.09 cubic meters/minute at 5.6 kg/cm2) based on 10 strokes per minute; air filter/regulator/lubricator with auto drain included.

Size & Weight 

  • 48" (122cm) Wide x 40" (102cm) Front to Back x 70" (178cm) High; Weight is 850 lbs. (386kg).

Optional Extras

  • Power Downfeeds of Sawheads, Clamps, Measuring Systems and Table Supports.

bottom of page