top of page

18" Special staggered blade toe notching saw

The Model N90 has been designed for a variety of heavy duty cutting applications, such as 45° double mitre cutting, notching of aluminum and plastic extrusions, or toe-notching of wood panels. This heavy duty machine can have blades set for notching or mitering. Blades move vertically on linear bearings on 1-1/4" (32mm) diameter hardened and ground rods. Keyed fences allow for each set-up and accurate dimensional changes.


  • Vertical Frame and Notching Saw

  • Blade Capacity: 16"

  • 3 H.P. 3 phase

  • Magnetic Starter

  • 2800 RPM

  • Cutting Capacity

  • Toe Notch Con g.: 6" X6"(deep)X 4" (high)

  • Mitre: 4"(wide)X 4" ( 4" X 6" available with extra charge)

Blade Capacity 

  • 16" OD (406mm); saw blades not included.

  • 18" OD (457mm); optional


  • 1" (25mm) with 3-1/2" (89mm) saw collars; mounted on preloaded and sealed bearings; 2-belt drive; 2800 RPM of spindle.

Motors & Voltages 

  • Two, 3 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motors, 60 Hz, 1725 RPM with Dual Magnetic Starter; 5 H.P. Motors available.

Table Base 

  • Precision machined and ground iron castings with milled keyways to guide fences; allows for easy and accurate dimensional changes.


  • Air operated by foot valve with cover.

Air Pressure & Consumption 

  • 6 CFM at 100 PSI (.17 cubic meters/minute at 7.03 kg/cm2) based on 6 strokes per minute; includes air filter/ regulator/lubricator with auto drain.

Size & Weight 

  • Standard Toe-Notch Machine 42" (107cm) Wide x 42" (107cm) front to back x 62" (157cm) High; Weight 900 lbs. (410kg).

Production Rate 

  • Up to 10 strokes per minute.

Cutting Capacity 

  • Staggered Saw Blades/ Toe-Notch Configuration; 6" (152mm) x 6" (152mm) Deep x 4" (102mm) High

  • Mitre Cutting/Staggered Saw Blades; 4-1/8" (105mm) Wide x 4" (102mm) High

  • Mitre Configuration/Non-Staggered Saw Blades; 4" (102mm) Wide x 4" (102mm) High; up to 6" (152mm) High with special blade guard modification at extra charge.

Floor Stand 

  • Heavy gage steel; stand is completely enclosed with 6" (152mm) dust collector outlet and scrap chute; 1200 CFM required.

Instructions Manual

bottom of page