top of page
BUY- NEW

20" Mitre cut-off saw

The CTD 400 Series Cut Off Saws are designed for heavy duty production cutting of aluminum, wood, plastics and steel. These rugged, heavy duty machines offer years of precision cutting.

Specifications

  • Mitre cut-off saw

  • Blade Capacity: 20"

  • 5 H.P. 3 phase

  • Magnetic Starter

  • 10 strokes per min

  • Mitres up to 45°

  • Cutting Capacity:

  • 45°: 5¼" X 8"

  • 90°: 5½" X 11½

Blade Capacity 

  • Models M416 & F426, 16" OD 406mm; Models M516 & F526, 20" OD 504mm; saw blades not included.

Arbor

  • 1" 25mm with 5" 127mm saw collars.

Spindle & Pivot 

  • Spindle mounted on preloaded and sealed bearings; with V-belt drive completely enclosed; pivot uses Timken bearings lubricated for life.

Motors & Starters 

  • 5 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motor with Magnetic Starter standard; 8½ H.P, 10 H.P., & 15 H.P. motors available as optional extra.

Floor Stand 

Table Base 

  • Precision machined cast iron base with milled keyways to guide fences; disc set flush with base.

Dust Outlet 

  • Two 4" (102mm) outlets provided; 1200 CFM required.

Production Rate 

  • Up to 10 strokes per minute; actual production rates will vary with the type and width of the material to be cut.
     

Actuation 

  • Hand operated standard; optional Power Downfeeds of Sawheads actuated by Two-Hand, Anti-Tie Down Maintained Contact Safety Control.

Air Pressure & Consumption 

  • 3 CFM at 80 PSI .09 cubic meters/minute at 5.6 kg/cm2 based on 10 strokes per minute; air filter/regulator/lubricator with auto drain included.

Size & Weight 

  • 48" 122cm Wide x 40" 102cm Front to Back x 70" 178cm High; Weight is 850 lbs. 386kg.

Optional Extras

  • Power downfeed of sawhead, clamps, measuring system and table supports.

  • Heavy gage steel sheet and angle.

contact
bottom of page