top of page
BUY- NEW

13" Vertical frame and notching saw

The Model N80 is used for a variety of cutting applications including 45° double mitre cutting, notching and bending of aluminum and plastic extrusions, or toe-notching of wood panels. This heavy duty machine can have blades set for notching or mitering. Blades move vertically on linear bearings on 1" (25mm) hardened and ground rods. Keyed fences allow for each set-up and accurate dimensional changes.

Specifications

  • Vertical Frame and Notching Saw

  • Blade Capacity: 13"

  • 2 H.P. 3phase

  • Magnetic Starter

  • 3450 RPM

  • Cutting Capacity:

  • Toe Notch Con g.: 4½"X4½" deep X3" high

  • Mitre: 3½ (wide)X 3" ( 3½" X 5" available with extra charge)

Blade Capacity 

  • 13" OD (330mm); saw blades not included.

Arbor

  • 1" (25mm) with 3" (76mm) saw collars; mounted on preloaded and sealed bearings; 2-belt drive; 3450 RPM of spindle.

Motors & Voltages 

  • Two, 2 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motors, 60 Hz, 3450 RPM with Dual Magnetic Starter; 3 H.P. Motors available.

Floor Stand 

  • Heavy gage steel; stand is completely enclosed with 6" (152mm) dust collector outlet and scrap chute; 1200 CFM required.

Actuation 

  • Air operated by foot valve with cover.

Air Pressure & Consumption 

  • 3 CFM at 80 PSI (.09 cubic meters/minute at 5.6 kg/cm2) based on 10 strokes per minute; includes air filter/ regulator/lubricator with auto drain.

Size & Weight 

  • 43" (109cm) Wide x 38" (97cm) front to back x 58" (147cm) High; Weight 750 lbs. (340kg).
     

Production Rate 

  • Up to 15 strokes per minute.

Cutting Capacity 

  • Staggered Saw Blades/ Toe-Notch Configuration; 4-1/2" (114mm) x 4-1/2" (114mm) Deep x 3" (76mm) High
    Mitre Cutting/Staggered Saw Blades; 3-1/2" (89mm) Wide x 3" (76mm) High
    Mitre Configuration/Non-Staggered Saw Blades; 3-3/8" (86mm) Wide x 3" (76mm) High; up to 5" (127mm) High with special blade guard modification at extra charge.

Instructions Manual

contact
bottom of page